Skip to content
golfclubcharts

Titleist SureFit chart

Tap a setting to read its loft and lie, pick the change you want, or type the letter and number on your hosel.

SureFit settings grid

Rows are loft, columns are lie. Gold outline: the setting the head ships in.

Hand
Head
Loft ↓ · Lie →1.5° up0.75° upStd0.75° flat
+1.5° loft
+0.75° loft
Std loft
−0.75° loft

Source: Titleist SureFit hosel settings

ABCD1234mark = settingstandard A1(left hand D4)

Read the two rings

The setting is the letter on one hosel ring and the number on the other that line up with the mark. Out of the box a right-handed head is A1.

Loft −0.75° … +1.5°Lie 0.75° flat … 1.5° up

Sixteen settings, two directions

Each setting is a mix of loft and lie. A driver or fairway moves 0.75° per step; a hybrid moves 1°, so the same letter and number change it more.

The settings people look for

You wantRight-hand settingChange
Most loftA4+1.5° loft
Least loftD1−0.75° loft
Most uprightA21.5° upright
FlattestB10.75° flat
Most loft on a hybridA4+2° loft

Source: Titleist SureFit hosel settings

Left-handed hosels use the same rings in a different order, so the codes do not carry over: switch the grid to Left hand before you turn the wrench. A left-handed head ships in D4.

How to change the setting

  1. Loosen the screw in the sole with the Titleist torque wrench and pull the head off the shaft.
  2. Turn the hosel rings until the letter and number you want line up with the mark.
  3. Push the head back on and tighten until the wrench clicks.
  4. Hit a few shots before you judge it: 0.75° of loft changes launch and spin, and lie changes start direction.
Loft and face angle move together

Adding loft with the hosel also closes the face a little at address, and taking loft off opens it. If the ball now starts left, that may be the face, not the lie. Check the lie your height calls for on the lie angle chart.

SureFit weights and club length

The weight screwed into the sole of a Titleist driver is part of the same system. Titleist lists which weight keeps the club balanced when the shaft is made longer or shorter than standard.

Length changeMen’sWomen’s
−1″+4 gStandard
−½″+2 g−2 g
0″ (standard length)Standard−4 g
+½″−2 g−4 g
+1″−4 g−4 g
HeadStandard weight
Titleist GT116 g
Titleist GTS313 g
Titleist GTS30014 g

Source: Titleist SureFit hosel settings

Changing length moves swing weight by about 3 points per half inch; the swing weight calculator shows what the weight swap puts back.

Questions golfers ask

What is the standard SureFit setting?

A1 on right-handed heads and D4 on left-handed heads: standard loft and standard lie.

Which SureFit setting adds the most loft?

A4 right-handed adds 1.5° of loft on a driver or fairway, with standard lie. On a hybrid, where each step is 1°, it adds 2°.

What does D1 mean on a Titleist driver?

Right-handed, D1 is −0.75° loft with standard lie. Left-handed, D1 reads differently; switch the grid to Left hand to see it.

Is the SureFit chart the same for hybrids?

The grid is the same, but each hybrid step is 1° instead of 0.75°. Switch the head to Hybrid and the grid rescales.

Does changing the SureFit setting change lie?

Most settings change both. The lie runs from 1.5° upright to 0.75° flat on a right-handed driver; read each cell for its pair.

What weight comes in a Titleist driver?

Titleist lists the standard weight as 16 g in the GT1, 13 g in the GTS3, 14 g in the GTS300. Its guide swaps it for a heavier or lighter one when the shaft is cut or extended.