Stock driver specs
| Driver | Stock length | Other lengths | Lie | Lofts | Swing weight |
|---|---|---|---|---|---|
| PING G440 K | 46″ | 45½″ | 58.5° | 9°, 10.5°, 12° | D3 |
| Titleist GTS2 | 45½″ | – | 58.5° | 8°, 9°, 10°, 11° | – |
| PING G Le4 (women) | 45″ | – | 58.5° | 11.5° | C3 |
| PING Prodi G (junior) | 39½″ | 34″–43¾″ | – | 15° | – |
Source: PING G440 K driver specifications; Titleist GTS2 driver specifications; PING G Le4 driver (women) specifications; PING Prodi G junior clubs specifications
Titleist builds the same GTS2 head at 44½″ for women and 42½″ for juniors. PING sells a separate women’s driver, the G Le4, at 45″, and the Prodi G junior driver starts at 39½″ and adjusts from 34″ to 43¾″ as a child grows. The women’s length chart and the junior size chart cover the rest of those sets.
Where the length rule came from
| Limit | Length | Where it applies |
|---|---|---|
| Equipment Rules | 48″ | Every round under the Rules of Golf |
| Model Local Rule G-10 | 46″ | Only events whose committee adopts it, from 1 January 2022 |
Source: USGA and R&A Model Local Rule G-10 (club length)
The local rule targets elite events; club competitions rarely adopt it, so check the terms of the event. The official gauge measures with the club soled at its lie, so a tape along the shaft is not the test. Putters are not covered.
Should your driver be shorter?
- Start from stock. Most men fit the PING middle band (169–183 cm), so the driver stays at 46″ or 45½″.
- Check the strike. Spray a face with powder spray and hit ten drives. Hits scattered toe and heel suggest trying a shorter build.
- Try ½″ down first. Grip down half an inch for a range session before cutting; if center hits go up, cut and re-weight.
- Re-weight after cutting. D3 becomes D0 at −½ in; add about 6 g to the head to get back.
PING’s chart adds +½ in and more above 184 cm. In a round under G-10, keep the driver at 46″ and take the extra length in the irons instead, where no limit applies. The length calculator gives the iron numbers.
Measuring your own driver
Lay a 48″ club ruler along the back of the shaft with the club soled at its lie, heel against the ruler’s end, and read at the end of the grip cap. A tape run along the front of the shaft reads long because it follows the hosel’s curve. Loft and lie settings on an adjustable hosel do not change length; the SureFit chart shows what each setting does change.