Skip to content
golfclubcharts

Golf club length calculator

Type your height and wrist-to-floor. You get both fitting methods, every club in the set you pick, the lie and the dot to order.

Your club lengths

Height alone gives a length; adding wrist-to-floor adds the lie and a second method to check it.

Golfer
Compare against
Units

My length and lie

6′1″ · WTF 36″

+½ inevery club

Height only (PING band)+½ in184–191 cm band
Height + wrist-to-floor (Wishon)+½ inlie +2° upright
Your 7 iron37½″standard 37″
Your driver46½″standard 46″

Both methods agree, so the length is a safe order.

Lie change +2° upright, nearest PING dot Green.

Over the 46 in limit of Local Rule G-10 (used in many elite events); the Rules allow up to 48 in.

ClubStandardYours±LoftLieSwing weight
Driver46″46½″+½ in10.5°60.5°D3 → D6
3 wood43″43½″+½ in15°58°D2 → D5
4 wood43″43½″+½ in17°58°D2 → D5
5 wood42½″43″+½ in19°58.5°D2 → D5
7 wood42″42½″+½ in21°59°D2 → D5
9 wood41½″42″+½ in24°59.5°D2 → D5
2 hybrid40¾″41¼″+½ in17°59°D1 → D4
3 hybrid40¼″40¾″+½ in20°59.5°D1 → D4
4 hybrid39¾″40¼″+½ in23°60°D1 → D4
5 hybrid39¼″39¾″+½ in26°60.5°D1 → D4
6 hybrid38¾″39¼″+½ in30°61°D1 → D4
7 hybrid38¼″38¾″+½ in34°61.5°D1 → D4
4 iron39¼″39¾″+½ in19°62.5°D0 → D3
5 iron38½″39″+½ in22°63°–
6 iron37¾″38¼″+½ in25.5°63.5°–
7 iron37″37½″+½ in29°64°–
8 iron36½″37″+½ in33°64.8°–
9 iron36″36½″+½ in37°65.5°D0.5 → D3.5
Pitching wedge35½″36″+½ in42°66.1°D2 → D5
Utility / gap wedge35½″36″+½ in47°66.1°–
Sand wedge35½″36″+½ in56°66.4°D3 → D6

Set: PING G440 (men, steel). Swing weight shows the drift if the builder keeps the stock head weight (3 points per ½″).

36″ WTF+½ inlength+2° upright Green33″ WTFStandardlength−1° flat Redboth 6′1″

Same height, different set

At 6′1″ PING’s height chart says +½ in for everyone. Wishon’s chart splits by arm length: 36″ wrist-to-floor reads +½ in and +2° upright, 33″ reads Standard and −1° flat. The calculator prints both and says when they disagree.

C6C9D2D5D8+½ in+1 in−½ in−1 instock head weight kept

Length moves swing weight

Each ½″ of length moves swing weight about 3 points if the head is not changed. The result table shows it per club, so a G440 pitching wedge at D2 becomes D5 at +½ in.

PING G44037″ · 62° · 29°Titleist T15037″ · 63° · 32°

Pick the set you will buy

The same ± lands on different stock numbers. A G440 7 iron starts at 37″ and 62° lie; a T150 7 iron at 37″ and 63°. Switch “Compare against” to read the set you are ordering.

Worked example: one golfer, two sets

  1. Input. 5′7″ in shoes, 32″ wrist-to-floor, Men, Titleist.
  2. Height only. 5′7″ is 170 cm, inside PING’s 169–183 cm band: Standard.
  3. Height and arms. Wishon’s row for 5′7″ and 32″ reads −½ in and −2° flat.
  4. They disagree, so the calculator goes with wrist-to-floor: the T150 7 iron becomes 36½″ at 61°, the PING Orange dot.
Why two methods

Height is easy to measure and PING’s fitters start with it. Wrist-to-floor measures where your hands actually hang, which is what length and lie fit. When the two agree, order with confidence; when they split, wrist-to-floor wins and a strike test on a lie board settles it.

What each input changes

InputMovesNotes
Height in shoesLength (PING band)Every club gets the same ±
Wrist-to-floorLength and lie (Wishon)Turns on the lie and the PING dot
GolferWhich standardMen, women’s set, or junior height bands
Compare againstThe stock numbersPING G440, Titleist T150 or PING G Le4
UnitsDisplay onlyInches or cm; the math stays the same

Juniors skip the set choice: below adult height the calculator switches to U.S. Kids height bands and PING Prodi G’s adjustable ranges, and the junior size chart lists every band.

Swing weight after a length change

Length changeD2 becomesPoints
+½ inD5+3
+1 inD8+6
−½ inC9-3
−1 inC6-6

Source: Club Champion: golf club swingweight explained; Ralph Maltby: swing weight per 1/2 inch of length

A builder can bring it back with head weight: about 2 g per point. Men’s sets usually sit D0–D5 and women’s C5–C9. The swing weight calculator does the head-weight math.

The two charts behind the numbers

PING height chart

7 bands from 151 to 201 cm, in ½″ steps from −1½ in to +1½ in. Length only.

Wishon height + wrist-to-floor

Rows from 27½″ to 41″ wrist-to-floor, each with a length and a lie. Pairs outside the chart are sent to a fitter, and the calculator names the closest row.

Source: PING Color Code Chart (lie colors and length by height); Wishon Golf: Height & Wrist-to-Floor Initial Length and Lie Fitting Charts

Taking the card to a shop

Print the spec card and hand it over with the set name. It lists stock and new length per club, loft, lie and the dot color, so a builder can order or bend without re-measuring. The lie still needs a check: hit five balls off a lie board with the 7 iron before every club is bent. Shaft and grip come next, on the flex chart and grip chart.

Questions golfers ask

How do I calculate what length golf clubs I need?

Measure height in shoes and wrist-to-floor, then enter both. Height alone gives PING’s band (from −1½ in to +1½ in); wrist-to-floor adds a lie and checks the length against Wishon’s chart.

Why does the calculator give two answers?

They are two fitting charts. At 6′1″ with 33″ wrist-to-floor PING reads +½ in and Wishon reads Standard. When they differ, the result uses wrist-to-floor because it measures your arms.

Do I need wrist-to-floor or is height enough?

Height is enough for a starting length. Without wrist-to-floor there is no lie or PING dot, and long- or short-armed golfers can be half an inch off.

How much does lengthening a club change swing weight?

About 3 points per half inch with the stock head: D2 goes to D5 at +½″ and D8 at +1″.

Does the calculator work for women and juniors?

Yes. Women compare against PING G Le4 or G440; juniors get the U.S. Kids height band and PING Prodi G ranges instead of a set standard.

Can I use cm?

Type 185 cm in any box, or switch Units to cm to show every length in centimetres.